GPX / FIT to CSV Converter

England, Scotland, Wales, Ireland & Northern Ireland, France, Germany, Italy, Spain, Portugal, Switzerland, Sweden, Norway, Andorra, Canada (Alberta, British Columbia), Australia, South Africa, Colombia, Canary Islands

USA: Arizona, Arkansas, California, Colorado, Georgia, Hawaii, Idaho, Illinois, Indiana, Kansas, Maryland, Massachusetts, Minnesota, Missouri, Montana, Nebraska, Nevada, New Mexico, New York, Ohio, Oregon, Texas, Vermont, Washington, West Virginia, Wisconsin, Wyoming

Anywhere else in the world converts too, with the country name only — roads, localities and regions need the areas listed above.

GPX / FIT Files*

Location Accuracy (meters)

Increase the value to have the Extractor look further around to find Towns, etc.

This value is converted to degree at equator equivalent and used as such. (dividing this input by 111132 - gives the value in degrees at equator)

Information Density (%)

Increase the value to have the Extractor filter information points in each layer to reduce density and overlaps.

The input value is a minimum separation between points expressed as a percentage of the overall distance. An input of 0 equals no filtering, an input of 5 on a 100km route equals a maximum of one information point per 5km.

Warning: increasing the value risks missing key information points

Named Trails: minimum section (km)

Named hiking and cycling routes the GPX follows, such as The Pennine Way, are listed in the Routes column.

Sections shorter than this are ignored, and a brief step off the trail shorter than this will not split one section in two. Lower the value to catch short stretches, raise it to report only the long ones.

Rivers and Lakes: minimum stretch (km)

Named rivers, canals, lakes and reservoirs the GPX travels alongside are added to the Landmarks column.

Stretches shorter than this are ignored. Where a river is reported this way, crossings of that same river over the stretch are left out to avoid repeating the name.

Information Density per layer (%)

If no value is provided, the global value is used.

road_code

road_name

landmark

province

region

country

Places of Interest

Include named historic sites, museums, attractions and major bridges passed within 100 metres of the route in Landmarks, with Place of Interest in Symbols.

Include Places of Interest

Mountain Pass Extraction

Include mountain passes and peaks in the extraction output. When disabled, the Mountain Pass column will still exist but will be empty.

Include Mountain Passes

Surface Extraction

Include road surface information in the extraction output. When disabled, the Surface column will still exist but will be empty.

Include Surface

Simplify to Paved/Unpaved

Conversion might take up to 5 minutes if the GPX file is big/the location covered is new/big.